It’s Time to Tune Up Your Furnace!

We’re getting deep into the fall, which means if you haven’t already scheduled a checkup for your furnace, it’s important for you to get that done as soon as possible. While we might not get the same level of chill out here in California as they do in, say, Wisconsin, you still want to make sure your furnace is in good working order so you’re not stuck without heat when the mercury dips.

Here are just a few reasons why it’s so important to get a fall furnace checkup each year from a team specializing in heater repair in Visalia, CA:

  • Long-term savings: Sure, there’s going to be an initial payment associated with your maintenance checkup, but consider this—these checkups keep your machine in good operational condition, preventing larger issues from developing. They also give the technician an opportunity to inspect your system and see if there are any small problems that could become big ones if you don’t correct them immediately. The financial benefits of staying on top of preventative maintenance are ultimately significantly greater than those of trying to save money by not bringing in the repair team.
  • Longer life: Just like keeping up with your regular preventative maintenance in your car will keep it on the road for longer, keeping up with your furnace’s preventative maintenance will help it stay in operation for years to come. While an average furnace will last for around 15 years, you can help extend that lifespan by keeping up with your maintenance.
  • Warranty reasons: If you recently purchased a new furnace, you might be required to get preventative maintenance checks done every year to keep your warranty active. This is crucial—if you suffer an expensive breakdown within the first couple years after a purchase, you’ll want to make sure your warranty covers the cost of repairs. Therefore, you shouldn’t do anything that would invalidate that warranty.
  • Proper airflow: Having your furnace checked and maintained will ensure proper airflow and air pressure. Without proper airflow, the warm air will not travel to where you need it in your home.
  • Stay safe: As furnaces get older, there starts to be a greater risk of cracks forming in the heat exchanger, which can result in carbon monoxide leaking into your home. Therefore, it’s important to have this annual tune-up done so you can be sure you’re staying safe and avoiding carbon monoxide or other issues, such as smoke or fires.
  • Cleaner operation: Even if your furnace is still performing perfectly, you probably are going to have a lot of dust inside the system at the start of each year that will burn off when you start using it. Remove some of this dust and debris from the furnace and it will operate more efficiently.

For more information about the various options you have available for your heater repair in Visalia, CA, or to schedule service, we encourage you to contact our team of technicians at McGee Refrigeration today.

My Heater Isn’t Blowing Air—Do I Need Furnace Repair?

It’s a problem no homeowner wants to encounter, yet it happens to the best of us. Your furnace is running, and you suddenly notice the heater is no longer blowing hot air. What’s going on? Is this something you can troubleshoot yourself? Should you call for furnace repair in Visalia, CA?

If you experience this problem, it may be caused by one of several issues. Some of these you can fix yourself. For others, it is best to call a professional:

  • The filter is dirty: When the filter gets filthy, it blocks the return airflow to the furnace. This will reduce the volume of hot air that the furnace blows into your home. Before you call for heater repair in Visalia, CA, check your filter. If it is dirty, change it. This could solve your problem. Remember to check your filter each month and change it at least every 90 days.
  • The thermostat is to blame: If your thermostat isn’t working properly, your furnace won’t either. First, check the batteries in your thermostat. Blow out any debris and dust that have accumulated in the thermostat panel. Next, make sure the thermostat is set to heat instead of cool. Lastly, set your thermostat five degrees above the current room temperature to see if it will come on. If it is still not working, contact a professional for furnace repair in Visalia, CA.
  • The blower motor panel is open: If your blower’s motor panel is not fully closed, your furnace will not run. A safety device prevents the furnace from operating. Shut this securely for proper operation of your furnace. This quick fix could help you avoid the cost of heater repair in Visalia, CA.
  • The power is out: This may sound obvious, but it’s possible there is an issue with the circuit breaker. Verify that the circuit breaker to your furnace is on. The fan may have its own breaker, so be sure to check it, too. Then, look for an on/off switch near your furnace that may be in the off position. If you turn these on and a breaker trips again, you may have an electrical issue. In this case, contact a professional for furnace repair in Visalia, CA.
  • The gas valve is closed: During repairs or inspection, the gas valve may have been shut off. To resume proper operation of your furnace, simply turn it back on. The handle should be parallel with the gas pipe for the “on” position.
  • Your ducts are leaking: First, check to make sure your vents are fully open. If they are, but some areas of your home are still not receiving hot air, you may have leaky ductwork. The ducts probably have gaps, holes or cracks that are allowing the hot air to escape. This wastes energy and creates poor heating for your home, so be sure to call a professional for heater repair in Visalia, CA sooner rather than later.

Never hesitate to contact your trusted local HVAC contractor if you’re experiencing problems with your furnace. Professional heater repair in Visalia, CA will help you determine the issue and restore your furnace to optimal operation.

Avoid Heater Repair in Visalia, CA This Winter with Proper Preparation

Don’t get caught in the cold this winter. Prepare your heater with a few easy steps that will keep your system operating smoothly this season. These simple maintenance tips will help you avoid costly heater repair in Visalia, CA. Before the cold weather hits, check off the following maintenance items:

  • Professional inspection: Before winter arrives, call an HVAC contractor in Visalia, CA for a routine inspection. This professional once-over will help identify any potential issues with your heater. The experienced technicians at McGee Refrigeration will inform you of any needed repairs or maintenance, so you can be prepared for the season. We can fix minor issues before they become major repairs.
  • Remove hazards: Furnaces are often located in prime storage areas of the home. This makes it tempting to pile items around your furnace. While storing items nearby is typically fine, you must be careful about what you store there. Remove any potential fire hazards stored near your furnace. This will keep you and your property safe from blazes that can begin when items get too close to the heat source.
  • Replace the filter: If you haven’t done so recently, replace the filter in your furnace. This is the easiest way to prolong the life of your furnace. A fresh, clear filter will keep it running optimally and save on energy bills. You should replace your filter every 30 to 90 days, depending on use and the number of pets in the home. A good rule of thumb is to check it at the beginning of each month and replace it if it’s dirty. Never go more than three months without replacing it.
  • Clear the airflow: You or your HVAC contractor in Visalia, CA should inspect your vents for blockages. Remove anything that could prevent or restrict airflow. You may need to clean vents, move furniture or make other adjustments to ensure proper airflow for the season. If airflow is blocked, your furnace has to work harder to achieve the desired temperature level. This results in wasted energy as well as less comfortable surroundings. Maintain clear airflow to prevent your furnace from overworking and help you avoid the need for heater repair in Visalia, CA.
  • Consider a new thermostat: Is your HVAC system equipped with a programmable thermostat? This will allow you to set the temperature for varying conditions. The system will automatically reduce the temperature at night, raise it during waking hours or lower it while you are away at work. This enhanced control can help you save on your utility bill this winter. With today’s technology, some thermostats even allow you to adjust the temperature remotely.

How many of these items have you checked off your list? Contact the professional technicians at McGee Refrigeration today to schedule your inspection. We will ensure your system is ready for winter with a thorough overview of your furnace. This quick and easy appointment can save you time and money down the road. Reach out to us today to schedule an appointment.